company news about How to maintenance Flexo Printer Slotter Die Cutter Machine?

How should flexo printer slotter die cutting equipment be maintained?
To guarantee steady performance and prolong its service life, flexo printer slotter die cutter maintenance is essential. Here is a thorough maintenance procedure:
1. Consistent upkeep
Maintenance of lubrication
In the beginning, lubricating flexo printer slotter die cutter tracks, bearings, etc. should be done roughly every six months; after a year, it should be done every four months. Select an appropriate lubricant to lubricate the bearings, transmission parts, etc., based on the machine's operating conditions and frequency of use. This will minimize component wear and increase the equipment's service life.
Examining screws
Every six months, inspect the machine's visible screws to make sure they aren't falling and breaking the device.
Inspection of ground wires
To keep the ground wire from loosening or being removed by others, check that it is fully linked to it every six months.
upkeep of the environment
Maintain the flexo printer slotter die cutter's operating environment clean by keeping the temperature between 10 and 30 degrees and the relative humidity between 30% and 50%.
Make sure the cardboard's printed surface is clean. To avoid scratching the nozzle when printing multi-layer or double-layer cartons, raise the machine head. When the machine is not operating for an extended period of time, keep the nozzle capped.

2. Upkeep of crucial components
Bearings, rollers, sprockets, cams, and gears
These components are crucial to the slotter die cutter and flexo printer. When maintaining them, be mindful of how they differ from other parts because the printing quality will be impacted by the variation in precision. Check these parts' accuracy variations and level of damage on a regular basis. They should be changed or adjusted as soon as possible if there are issues such excessive wear and looseness.
3. Upkeep of the ink system
Anilox roller and ink roller
Uneven inking will result from a worn surface or dried ink. Grinding can fix minor wear, but replacing severe wear requires soaking and wiping the dried ink with a specific solvent.
The ink tube and the ink pump
The ink supply will be impacted if the ink pump and ink tube are blocked. To guarantee smooth ink circulation, periodically check the flexo printer slotter die cutter ink pump's operation and clean or replace the clogged ink tube and filter.
4. Maintenance of electrical systems
Electrical parts
Verify whether the electrical components of the flexo printer slotter die cutter are connected loosely and whether the terminal is oxidized and corroded. If there are any issues, tighten, clean, or replace them as soon as possible.
The motor
Check for carbon brush wear, clean the internal winding, replenish the bearing lubrication, disassemble the motor, and make sure the power output is steady and the motor operates smoothly.
System of control
To ensure the regular automation control functions of the printing press, such as paper detection, registration control, and ink balance control, use specialized testing equipment to test the flexo printer slotter die cutter's control system, calibrate the sensor's sensitivity, and inspect the circuit board for damage or cold soldered electronic components.